Centrifuges

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Beckman Optima TL Ultracentrifuge w/ Beckman TLA 100.4 Rotor Spares/Repair

ITEM-42968

Beckman Optima TL Ultracentrifuge

This item was removed from a university laboratory where it was surplus to requirements.

It powers on and is in good cosmetic condition with minimal wear. However, the unit is non-operational: it does not run programs or operate normally. The door does not open unless the unit is manually stripped down and the door lock pin is pressed.

Additionally, the vacuum chamber does not hold pressure. Error messages displayed include CPU, VAC, and SPD.

Therefore, it is listed as Spares/Repair.

Includes:

Rotor: Beckman TLA 100.4
Maximum Speed: 100,000 RPM
Serial No.: 95U1272

Model: TL

Serial No.: CTL95E13

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Eppendorf 5804 R Centrifuge Lab Spares/Repairs

ITEM-45431

Eppendorf 5804 R Centrifuge Lab

This item was removed from a university where it was surplus to requirements.

The centrifuge powers on and is in good cosmetic condition. However, it displays "Error 14," indicating an electrical fault, and also has a faulty lid locking mechanism.

Due to both errors listed above, this item is listed as Spares/Repair.

Specifications:

Model: 5804 R
Serial No.: 5805CI964308

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Sorvall RC-3B Plus Floor Standing Centrifuge - Spares/Repair Lab

ITEM-46525

Sorvall RC-3B Plus Floor Standing Centrifuge - Spares/Repair Lab

This item was removed from a university where it was surplus to requirement.

It is in reasonably good cosmetic condition but has not been tested on site due to the service report attached stating;

Rotor lock: Seized, cannot remove rotor

No reported problems Service and check as above Unit is old

Note 6: door seal has shrunk and will not go back into place

Note 9: chamber is corroded due to substance.

Note 10: gas struts have failed, lid is heavy and can fall.

Note 12: drive shaft housing corroded.

Therefore, it is listed as Spares/Repair.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Sorvall RC-28S Floor-Standing Centrifuge Spares/Repair Lab

ITEM-46923

Sorvall RC 28S Floor-Standing Centrifuge Spares/Repair Lab

This item was removed from a university lab where it was surplus to requirement.

It is in reasonably good cosmetic condition and powers on, however, testing could not be completed due to an on-screen error that prevented further operation, and prevented a vacuum from being drawn.

Therefore, it is listed as Spares/Repair.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Beckman Allegra X-22R Benchtop Centrifuge Spares/Repair Lab

ITEM-47198

Beckman Allegra X-22R Benchtop Centrifuge – Spares/Repair

This item was removed from a university lab where it was surplus to requirement.

It powers on and is in good cosmetic condition. However, it has been identified as having a faulty fan, compromised vibration dampers, and issues with motor suspension.

Therefore, this item is being sold strictly as Spares/Repair.

Includes:

Beckman Allegra X-22R unit only (no rotor or accessories included)

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Thermo Scientific Heraeus Megafuge 40R Laboratory Centrifuge Lab Spares/Repair

ITEM-47420

Thermo Scientific Megafuge 40R Centrifuge

This item was removed from a university laboratory where it was surplus to requirements.

The casing is in good used cosmetic condition. However, following internal components have been removed:

2 x lid locks/mechanisms
1 x motor

The main board is present but faulty and displays an E33 error on startup. The condition of other internal components—including the compressor, display, and temperature sensor is unknown and has not been tested.

Therefore, it is listed as Spares/Repair.

Please note: There is no rotor included.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Thermo Scientific Heraeus Megafuge 40R Laboratory Centrifuge Lab Spares/Repair

ITEM-47421

Thermo Scientific Megafuge 40R Centrifuge

This item was removed from a university laboratory where it was surplus to requirements.

The centrifuge displays an E33 error, indicating a fault with the main board. The working condition of the remaining parts is unknown:

2 x Lid locks (at least one reported to have an issue)
1 x Motor
1 x Compressor
1 x Display board
1 x Temperature sensor

Due to the issues stated above, this centrifuge is listed as Spares/Repair.

Please note: There is no rotor included.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Hermle Z 300 K Centrifuge - Spares/Repair Lab

ITEM-47684

Hermle Z 300 K Centrifuge

This item was removed from a university laboratory where it was surplus to requirements.

It powers on and shows minimal wear.

However, during testing it failed to reach the set temperature, stabilizing at 25°C, and did not achieve the rotor’s maximum speed of 5000 RPM, reaching only 4000 RPM.

Therefore, it is listed as spares/repair.

Model: Z 300 K

Serial No.: 55060105

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Eppendorf Centrifuge 5810 R w/ Eppendorf A-4-81 Rotor Spares/Repair Lab

ITEM-47794

Eppendorf 5810 R Refrigerated Centrifuge - Spares or Repair

This item was removed from a university where it was surplus to requirements.

It is in good cosmetic condition but does not power on, likely due to a suspected motherboard fault. Therefore, it is being sold as Spares or Repair.

Includes:

4 x Swinging Buckets (Eppendorf 09/04 – Max Load 780g)
8 x Sample Holders (5-hole, 3cm diameter)
4 x Sample Holders (1-hole, 6cm diameter)
1 x Sample Holder (12-hole, 2cm diameter)

£ 500.00 (ex. VAT) 1 in stock

MSE Mistral 2L Floor Standing Centrifuge w/ Rotor Lab

ITEM-48544

MSE Mistral 2L Floor Standing Centrifuge w/ Swing-Out Rotor Lab

This item was removed from a university where it was surplus to requirement.

It is in reasonably good cosmetic condition and in good working order.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Beckman Coulter Avanti J-20 XP Floor Standing Centrifuge Spares/Repair Lab

ITEM-49365

Beckman Coulter Avanti J-20 XP Floor Standing Centrifuge Spares/Repair Lab

This item was removed from a university where it was surplus to requirement.

It is in reasonably good cosmetic condition but fails to powers on, it is therefore listed as Spares/Repair

Please note; There is no rotor included.

SPARES/REPAIR ITEM

£ 500.00 (ex. VAT) 1 in stock

Eppendorf 5804 R Centrifuge w/ A-4-62 Rotor Spares/Repair Lab

ITEM-49742

Eppendorf 5804 R Centrifuge w/ A-4-62 Rotor Spares/Repair Lab

This item was removed from a university where it was surplus to requirement.

It is in good cosmetic condition and powers on, however during testing the following error was present; Error 17, a PCB fault.

Which prevented any further testing.

It is therefore listed as Spares/Repair.

£ 400.00 (ex. VAT) 1 in stock

ALC PK121 Multispeed Benchtop Centrifuge w/ ALC T515 Swinging Bucket Rotor Lab

ITEM-47205

ALC PK121 Multispeed Benchtop Centrifuge Lab

This item was removed from a university where it was surplus to requirement.

It is in good cosmetic condition with some rust spots visible inside and is in good working order.

Includes;

ALC T515 Swinging Bucket Rotor w/ 4 x Buckets.

£ 350.00 (ex. VAT) 1 in stock

Sorvall Instruments RC5C Floor Standing Centrifuge Spares/Repairs

ITEM-47290

Sorvall Instruments RC5C Floor Standing Centrifuge - Spares/Repair Lab

This item was removed from a university laboratory where it was surplus to requirements.

It is in good cosmetic condition and has been tested using an SA-600 rotor (not included) at the rotor's maximum speed of 16,500 rpm.

However, during temperature testing it failed to reach its minimum set point of -20°C, only achieving -8°C.

Therefore, it is listed as Spares/Repair.

Please note; There is not rotor included.

£ 350.00 (ex. VAT) 1 in stock

Beckman J2-21 Floor Standing Centrifuge with JA10 10000rpm Rotor Lab

ITEM-32037

Beckman J2-21 Floor Standing Centrifuge

This was removed from a university lab where it was surplus to requirements.

The unit powers up and is in full working order. It is in good cosmetic condition with only minor marks from use.

Included are;

Beckman J2 - 21 Centrifuge

Cat no. 341737

SN - E948

Rotor Type - JA 10

SN - 17342

10,000rpm Max

Hold 6 x Buckets 7cm diameter

£ 350.00 (ex. VAT) 1 in stock

Heraeus Labofuge 400 Function Line Benchtop Centrifuge 3500rpm Max Lab

ITEM-36950

Heraeus Labofuge 400 Function Line Benchtop Centrifuge

This was removed from a university lab where it was surplus to requirements.

The unit powers up and runs smoothly up to 3500rpm.

It is in reasonable cosmetic condition with light marks and rusting.

Heraeus Rotor #8179

4 x Buckets #8172 Ch.003515

£ 300.00 (ex. VAT) 1 in stock

MSE Falcon 6/300 Centrifuge w/ MSE Swing Out Rotor Lab

ITEM-36610

MSE Falcon 6/300 Centrifuge

This item was removed from a university where it was surplus to requirement.

It is in good cosmetic condition and powers on and runs well with he fitted rotor, though we are told it will not go higher than 3000, even with a higher rated rotor.

This item also includes the following:

1 x Mistral MSE Rotor - 43124

Capacity: 4 x 750ml
SN: 986766
Max RPM: 2500
(There are no rotor buckets included)

£ 100.00 (ex. VAT) 1 in stock

Centurion Cell-Prep 4050 Benchtop Centrifuge Lab

ITEM-32099

Centurion Scientific Centrifuge 4050 Series Cell-Prep

This item was removed from a university laboratory where it was surplus to requirements.

The centrifuge is in reasonable cosmetic condition, with visible signs of wear and some rust.

It powers on without issue and has been tested to operate at 50 RPM, 100 RPM, and its top speed of 200 RPM.

Included Components:

12-bay centrifuge rotor
1x balance weight

Specifications.

Model: 4050 Series Cell-Prep
Serial No.: 98042157