Centrifugation

£ 725.00 (ex. VAT) 1 in stock

Beckman J2-21 Floor Standing Centrifuge 20000rpm Max Lab

ITEM-20251

This Beckman J2-21 Floor Standing Centrifuge was removed from a university lab where it was surplus to requirements.

We have replaced the lid and repaired an area of cracked plastic underneath it. It is very stable. There are some cracks around the gas strut area. They do not appear to affect the operation of the unit.

The unit is functional and has a comprehensive service history.

The centrifuge holds a vacuum well and has been tested at:

5,000rpm

10,000rpm

15,000rpm

20,000rpm (Max).

It ran fine at all these speeds but the needle isn't totally in sync with the control knob.

It has been tested at the following temperatures:

0ºC our thermometer read -15.8ºC

20ºC our thermometer read 21.2ºC

It appears to probably have a cooling issue. The compressor etc runs fine. It just appears to drop lower than it is set. When set to higher temps, it takes quite a while to heat up.

SPARES/REPAIR ITEM

£ 725.00 (ex. VAT) 1 in stock

Beckman L8-60MR Ultracentrifuge Lab Spares/Repairs

ITEM-39709

Beckman L8-60MR Ultracentrifuge

This was removed from a university lab where it was surplus to requirements.

The unit powers up and was tested with a Beckman 70.1 Ti rotor from another item (Not included), but would not reach over 3000rpm (Rotor max is 10000). We suspect there is a vacuum issue as the vacuum light flashed red during testing. The system also will not cool down.

It is in otherwise good cosmetic condition.

It is sold for spares/repairs.

Beckman L8-60MR Ultracentrifuge

Model: L8-60MR

Serial#: 6H816

Year: 1988

£ 715.00 (ex. VAT) 1 in stock

Haraeus Biofuge Haemo Centrifuge with 1067 Haematocrit Dish Rotor Lab

ITEM-25993

This Haraeus Biofuge Haemo Centrifuge was removed from a university lab where it was surplus to requirements.

The unit is in good cosmetic condition with minor marks from use. It is in full working order, running up to 13000rpm.

It is fitted with a plate rotor.

£ 695.00 (ex. VAT) 1 in stock

Jouan BR3.11 Refrigerated Benchtop Centrifuge Lab

ITEM-29891

This Jouan BR3.11 Refrigerated Benchtop Centrifuge was removed from a university lab where it was surplus to requirements

The unit powers up and is in good working order, but the lid has to be opened manually. The automatic switch is broken

It is in good cosmetic condition with minor marks.

Rotor Arm:

Max Load 2.8kg

Max RPM 5150

Buckets x 2:

Dimensions L5.5cm x W5.5cm x H9.5cm

Rotor:

Part No. 803

6 Hole

Dimensions L2cm x W2cm x H4cm

£ 680.00 (ex. VAT) 1 in stock

Sanyo MSE Mistral 2000R Benchtop Refrigerated 4500rpm Centrifuge Lab

ITEM-31287

Sanyo MSE Mistral 2000R Benchtop Refrigerated 4500rpm Centrifuge

This was removed from a university lab where it was surplus to requirements.

The unit powers up and is in full working order up to 4500rpm. It refrigerated well. It is in good cosmetic condition with minor marks from use.

The buckets have 2 x (6 x 15 mil) & 2 x (1 x 50 mil) adapters.

£ 680.00 (ex. VAT) 1 in stock

Hermle Microlitre Benchtop Refrigerated Centrifuge Z216MK Lab

ITEM-23943

This Hermle Microlitre Benchtop Refrigerated Centrifuge Z216MK was removed from a university lab where it was surplus to requirements.

We powered the unit on with no issues. The chiller worked to -20C showing -21.6C on our digital thermometer (not included).

The rotor fitted can take 24 tubes, and had a maximum speed of 2000rpm. It runs smoothly.

It is in very good condition with minor marks.

SPARES/REPAIR ITEM

£ 675.00 (ex. VAT) 1 in stock

Thermo Scientific Centrifuge Casing & Buckets H-6000/HBB-6/HLR-6 Lab

ITEM-23422

Thermo Scientific Centrifuge Shell & Buckets H-6000/HBB-6/HLR-6

This was removed from a university lab where it was surplus to requirements. There is no rotor included. this is just for the shell and the buckets.

The item is in reasonable cosmetic condition but has marks from use.

It comes with 6x Thermo Scientific Buckets - PN 44040

max. Mass: 2575g

Diameter: 95.79mm

Depth: 127.07mm

RECERTIFIED ITEM

£ 645.00 (ex. VAT) 1 in stock

Eppendorf 5810 Benchtop Laboratory Centrifuge Lab

ITEM-31541

This Eppendorf 5810 Benchtop Laboratory Centrifuge was removed from a university lab where it was surplus to requirements.

The unit has been tested by a service engineer and is in full working order. It ran smoothly and quietly. There is no rotor included.

It is in excellent cosmetic condition with only minor marks from use.

£ 630.00 (ex. VAT) 1 in stock

Sanyo MSE Harrier 18/80 Refrigerated Centrifuge with 6000rpm Rotor Lab

ITEM-30455

This Sanyo MSE Harrier 18/80 Refrigerated Centrifuge was removed from a university lab where it was surplus to requirements.

The unit powers up and is in reasonably good cosmetic condition with marks from use.

It is in full working order. The rotor spins up to 6000rpm and the refrigeration works and has been tested at 4˚C and -9˚C.

MSE Rotor 43124-141

Max RPM - 6000

4 x Buckets

4 x Yellow Adaptors hold 1 x 50ml tube each

£ 615.00 (ex. VAT) 1 in stock

Hettich Mikro 185 Microcentrifuge with 13300rpm Rotor Lab

ITEM-35636

Hettich Mikro 185 Microcentrifuge with 13300rpm Rotor

This was removed from a university lab where it was surplus to requirements.

The unit powers up and is in good working order.

There are 49,958 cycles remaining out of 50,000 which implies that the item has been rarely used

Max RPM- 13300

Includes rotor. The rotor holds 24 x 3g tubes

£ 610.00 (ex. VAT) 1 in stock

Hettich Mikro 185 Benchtop Microcentrifuge with 13300rpm Rotor Lab

ITEM-35637

Hettich Mikro 185 Benchtop Microcentrifuge with 13300rpm Rotor

This was removed from a university lab where it was surplus to requirements.

It is in full working order.

There are 49,948 cycles remaining out of 50,000 which implies that the item has been rarely used

The lid is in working order.

Includes 13300rpm rotor. The rotor holds 24 x 3g tubes

£ 600.00 (ex. VAT) 1 in stock

Sanyo MSE Mistral 2000R Refrigerated Benchtop Centrifuge with 4500rpm Rotor Lab

ITEM-30547

This Sanyo MSE Mistral 2000R Refrigerated Benchtop Centrifuge was removed from a university lab where it was surplus to requirements.

The unit has been tested and is in working order. The RPM could be set up to 6500 but the rotor would only run up to 4500rpm.

It was tested with a digital thermometer (not included).

When the temperature was set to 4˚c, the thermometer read 5˚c

When the temperature was set to -4˚c (minimum) the thermometer read -5˚c

There is a Rotor inside with 4 x Buckets and 2 x Yellow 50ml Adaptors.

It is in reasonably good cosmetic condition but has some minor marks from use.

RECERTIFIED ITEM

£ 595.00 (ex. VAT) 1 in stock

Sigma 1-15K Refrigerated Benchtop Centrifuge Lab

ITEM-30220

This Sigma 1-15K Refrigerated Benchtop Centrifuge was removed from a university lab where it was surplus to requirements.

The unit has been recertified by a service engineer. It is in full working order. It has had a new gas strut fitted, but the lid can get stuck. Once it is opened it will repeatedly open, but when left for an amount of time it can get stuck again.

It is in excellent cosmetic condition with some minor marks from use.

£ 575.00 (ex. VAT) 1 in stock

MSE Sanyo HAWK 15/05 Refrigerated Benchtop Centrifuge MSB005.CR1.K Lab

ITEM-30375

This MSE Sanyo HAWK 15/05 Refrigerated Benchtop Centrifuge was removed from a university lab where it was surplus to requirements.

The unit powers up and is in full working order up to 15000rpm. The refrigeration works well.

It is in good cosmetic condition with minor marks from use.

The rotor has 25x2ml Buckets

RECERTIFIED ITEM

£ 570.00 (ex. VAT) 1 in stock

Thermo Electron Corporation Jouan c4i Benchtop Centrifuge w/ 4750rpm Rotor Lab

ITEM-31858

This Thermo Electron Corporation Jouan c4i Benchtop Centrifuge was removed from a university lab where it was surplus to requirements.

The unit powers up and is in full working order. The rotor is created for 4750rpm, but the unit's max speed with M4 buckets is 4000rpm.

It is in good cosmetic condition with minor marks from use.

£ 560.00 (ex. VAT) 1 in stock

Du Pont Sorvall Benchtop Centrifuge Model - RT 6000D with H1000B 3600RPM Rotor

ITEM-25304

This Du Pont Sorvall Benchtop Centrifuge Model - RT 6000D with H1000B 3600RPM Rotor was removed from a university lab where it was surplus to requirements.

The item powers on with rotor speed running smoothly up to 3600rpm.

The temperature was first set to 4˚c which it reached quickly. The temperature was then set to its minimum setting of -20˚c. After an hour of running, the display read -14˚c but the thermometer was reading -20˚c.

The item is in a reasonable, used cosmetic condition with marks from use.

Rotor:-

Du Pont Instruments Sorvall H1000B

3600 Max RPM

4 x Sorvall Buckets (PN - 11053)

15 x Sorvall bucket adapters:-

1 x Green 00455 for 4 x 50ml tubes

2 x Green 00836 for 35 x 5ml tubes

2 x Black 00884 for 10 x 15ml tubes

2 x Purple 00847 for 20 x 12ml tubes

4 x Blue 00904 for 4 x 50ml tubes

4 x Yellow 00186 for 1 tube - diameter 63mm

£ 540.00 (ex. VAT) 1 in stock

Sigma 2-16P Centrifuge with Nr.12148 15300/min Rotor Lab

ITEM-28148

This Sigma 2-16P Centrifuge with Nr.12148 15300/min Rotor was removed from a university lab where it was surplus to requirements.

The unit powers up and is in full working order. It does begin to whistle above 10000rpm, but we believe this is just down to the lid seal.

It has had new lid struts fitted and new QR lid release plugs.

With it is a Sigma Nr.12148 15300/min Centrifuge Rotor.

Good used condition.

Measures:

Approx 17cm.

Centre bore: 10.8mm.

Tube holes: 10.8 x 36.2mm.

24 sample holes.

£ 535.00 (ex. VAT) 1 in stock

Sorvall TH641 Swinging Bucket Rotor 41,000 Max RPM w/ 6 x BucketsLab

ITEM-31491

This Sorvall TH641 Swinging Bucket Rotor was removed from a university lab where it was surplus to requirements.

The unit is in good cosmetic condition but has not been tested. It will need to be inspected for safety by a qualified technician before it can be used again.

Sorvall TH641 Swinging Bucket Rotor

41,000 Max RPM

EQ. 40519231

6 x Sorval Buckets

Eq. 40519231

08229

105.5

Holds 1 x 13.2ml tube each

£ 525.00 (ex. VAT) 1 in stock

Thermo Heraeus Pico 17 Centrifuge & 75003424 Fixed Angle Rotor Lab

ITEM-36075

This Thermo Heraeus Pico 17 Centrifuge was removed from a university lab where it was surplus to requirements.

The unit powers up and is in good working order up to the max of 13000rpm. It is in good cosmetic condition with minor marks from use.

Thermo Heraus Pico 17 Centrifuge

Model#: Pico 17

Serial#: 40638289

Manf: 2006

Thermo 75003424 Fixed Angle Rotor

Model#: 75003424

Holds 24 x 1.5/2ml Tubes.

Max 14800rpm

It also comes with the original Allen key used to tighten the Rotor.

£ 525.00 (ex. VAT) 1 in stock

Thermo Heraeus Pico 17 Centrifuge w/ 75003424 Fixed Angle Rotor Lab

ITEM-36074

This Thermo Heraeus Pico 17 Centrifuge was removed from a university lab where it was surplus to requirements.

The unit powers up and is in good working order up to the max of 13000rpm. It is in good cosmetic condition with minor marks from use.

Thermo Heraus Pico 17 Centrifuge

Model#: Pico 17

Serial#: 40977042

Manf: 2009

Thermo 75003424 Fixed Angle Rotor

Model#: 75003424

Holds 24 x 1.5/2ml Tubes.

Max 14800rpm

It also comes with the original Allen key used to tighten the Rotor.

Centrifugation

Filters