Water Baths & Chillers
Items 1 to 20 of 66

£ 135.00 (ex. VAT) 1 in stock
Ultrawave U50 Ultrasonic Water Bath Lab
ITEM-18958
This Ultrawave U50 Ultrasonic Water Bath was removed from a university lab where it was surplus to requirements
The unit is in a very good used condition.
It powers up but it was not tested further.
Inner Dimensions: 15cm L x 8.5cm W x 6cm H.

£ 90.00 (ex. VAT) 1 in stock
3x Grant JB1 Heating Water Baths Lab - Spares / Repair
ITEM-13386
These units were removed from a lab during a clearout.
All units have plastic where the integrity of the material is compromised and probably not fit for use.
Therefore all are sold as spares or repairs as refurbishment is needed.
All baths are heated to about 83C so the heating functions are working.

£ POA 1 in stock
Affinity MRI CHILLER LYDALL 50HZ Model 1P T12789 for Bruker BioSpin Lab
ITEM-20058
This Affinity MRI CHILLER LYDALL 50HZ Model: 1P T12789 was removed from a university lab where it was surplus to requirements.
The unit powers up but it has not been tested further.
It is in reasonable cosmetic condition but has some rusting to the casing and screws. The case has quite a few marks from use.

£ POA 1 in stock
Amersham Biosciences Multitemp 3 Recirculating Water Bath 56-1165-34 Lab
ITEM-19892
This Amersham Biosciences Multitemp 3 Recirculating Water Bath Part no. 56-1165-34 was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with a digital thermometer (not included). It was set to the minimum of -10˚C which it quickly reached. It was then set to 37˚C and 90˚C which it also very quickly reached and held at. It seems to be in good working order.
It is in good cosmetic condition but it has some marks from use.

£ 109.51 (ex. VAT) 1 in stock
Boekel Scientific MicroCooler II Model 260010 Cooling Dry Bath Lab
ITEM-18200
This Boekel Scientific MicroCooler II Model 260010 Cooling Dry Bath was removed from a university lab where it was surplus to requirements.
The unit powers on and was set to -19 but only reached -14 after being left on for 8 hours. This seems to be the lowest temperature it will work at.
It is in reasonably good cosmetic condition but has marks from use.

£ 91.89 (ex. VAT) 1 in stock
Buchi B 465 Stainless Steel Heated Water Bath for Rotavapor Evaporator Lab
ITEM-08553
This Buchi B 465 Stainless Steel Heated Water Bath was removed from a university laboratory where it was surplus to requirements.
The unit powers on and seems to be working/heating properly.
Tested the product at 37 degrees and it hovered around 32. Tested the product at maximum (100 degrees) and it got up to 102 degrees.
It is in reasonably good condition but has strong signs of use.

£ 91.61 (ex. VAT) 1 in stock
Buchi B-465 Heating Water Bath Lab
ITEM-13157
This unit was removed from a lab during a clearout.
Unit is in OK condition but not great. When set to 37C, our thermometer was reading at 45-50C.
Unit actually reached up to a max of 90C.

£ 90.00 (ex. VAT) 1 in stock
Buchi Brinkmann W 240 Rotavapor Heating Water Bath Lab
ITEM-17466
This Buchi Brinkmann W 240 Rotavapor Heating Water Bath was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested. It heated to and held at 37C, but began to creep up to about 40 after a few minutes. On full power, it got to 98.5C.
It is in good cosmetic condition but has some marks from use.

£ 75.00 (ex. VAT) 1 in stock
Clifton NE2D Duo Water Bath 4 Litre + 8 Litre Digital DuoBath Lab Spares Repairs
ITEM-16037
This Clifton NE2D Duo Water Bath 4 Litre + 8 Litre Digital DuoBath was removed from a university laboratory where it was surplus to requirements.
The unit powers on but appears to be faulty on the 4-litre side. It doesn't heat up and keeps switching to "off". The 8-litre bath however seems to be functioning. It reached and held at 37C when set and reached 78C when set to 100, but did not get past 78C even after 6 hours of heating.
It is in very good condition cosmetically but has been used previously.

£ POA 1 in stock
Cole Parmer Circulating Bath with Polystat Temperature Controller 12108-35 Lab
ITEM-19891
This Cole Parmer Circulating Bath with Polystat Temperature Controller 12108-35 was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with a digital thermometer (not included). It was set to -50˚C and dropped to -14˚C on the display after about 6 hours. Our thermometer measured -27˚C.
It was then set to 37˚C which it reached quickly, and then 100˚C which it also reached quickly.
It is in good cosmetic condition but has some marks from use.

£ 450.00 (ex. VAT) 1 in stock
Cole Parmer Model 1268-92 Polystat Refrigerated Circulator Water Bath Lab
ITEM-19895
This Cole Parmer Model 1268-92 Polystat Refrigerated Circulator Water Bath was removed from a university lab where it was surplus to requirements.
The unit powers up and both the heating and cooling settings have been tested with a digital thermometer (not included). It was set to 37˚c which it quickly reached, then set to the max temp on the dial of 100˚c but it stopped heating up at 50˚c and didn't seem to be able to get any higher. We then set the dial to the minimum temp of -40˚c and it dropped to -25˚c after running for 6 hours or so but didn't seem to be dropping any further.
It is in reasonably good cosmetic condition but has some marks from use.
It appears to work well within the -25 to 50c range.

£ 547.31 (ex. VAT) 1 in stock
Cole-Parmer Polystat CR250WU Cooling Recirculator Lab
ITEM-16937
This Cole-Parmer Polystat CR250WU Cooling Recirculator was removed from a university lab where it was surplus to requirements.
The unit powers on and the pump/compressor sounds like it is running. You can feel the pump suck and blow quit strongly but we havn't tested it any further than that.
It is in very good cosmetic condition but has a slight mark on the rear panel from use.

£ 124.54 (ex. VAT) 1 in stock
Constant Temperature Bath CT-500 Mark Spares / repairs.
ITEM-02981
Constant Temperature Bath CT-500 Mark II spares/repairs.
The unit powers on but does not appear to heat the water.

£ 58.34 (ex. VAT) 1 in stock
Copley Scientific Heating Circulating Water Bath Lab
ITEM-08704
This Copley Scientific Heating Circulating Water Bath was removed from a university laboratory where it was surplus to requirements.
The unit powers on and has been tested at both 35 & 75 Celsius.
It is in good cosmetic condition but has been quite well used.

£ 74.39 (ex. VAT) 1 in stock
Copley Scientific Model NE4-COP Water Bath Heater and Stirrer Lab
ITEM-16443
This Copley Scientific Model NE4-COP Water Bath Heater and Stirrer was removed from a university lab where it was surplus to requirements.
The unit powers on and was tested at 37C which it held steadily. It only reached 49C though when turned all the way to max.
It is in very good cosmetic condition but has been previously used.
Please note this is just the heater - the water bath tank is not included.

£ POA 1 in stock
Fisher Scientific Isotemp 250LCU Cooling/Heating Recirculating Chiller Lab
ITEM-12270
This Fisher Scientific Isotemp 250LCU Cooling/Heating Recirculating Chiller was removed from a university lab where it was surplus to requirements.
The unit powers up but has not been tested further.
It is in good cosmetic condition but has some marks from use.

£ 292.61 (ex. VAT) 1 in stock
Fisher Scientific Isotemp 5L Heating Water Bath Model 2341 Lab
ITEM-16870
This Fisher Scientific Isotemp 5L Water Bath Model 2341 was removed from a lab during a clearance.
The unit powers on and has been tested at 37, 60 and 100 degrees celsius. It heats very accurately.
It is in reasonably good cosmetic condition but has been quite heavily used with lots of marks and staining.

£ POA 1 in stock
Fisher Scientific Unstirred Water Bath Type DMU19 Lab
ITEM-19387
ITEM-19387

£ POA 1 in stock
Fisions HAAKE SWB 20 Shaking Water Bath Lab
ITEM-19001
This Fisions HAAKE SWB 20 Shaking Water Bath was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with a digital thermometer.
When set to 35˚C it reached 35˚C.
When set to 110˚C it reached 77˚C. This is likely because there is no lid.
The shaker seems to work but stopped a few times during heating. The red button has to be pressed to continue.
It is in reasonably good cosmetic condition but has some marks from use.

£ POA 1 in stock
Grant GR150 R1 THERMO Recirculating Water Bath Chiller Lab Spares or Repairs
ITEM-20107
This Grant GR150 Recirculating Water Bath Chiller was removed from a university lab where it was surplus to requirements.
The unit powered up but blew its fuses. It was not tested further.
It is in reasonably poor cosmetic condition with marks from heavy use.
Included with this item are:
Grant Instruments
Model: Type R1 THERMO
Thermometric 5520 PreThermostat
Type: GR150 THERMO
Items 1 to 20 of 66