All Products
Items 2901 to 2920 of 3286

£ 1,650.00 (ex. VAT) 1 in stock
Thermo Scientific FiberLite F14-6x250y Centrifuge Rotor Lab
ITEM-13904
This Thermo Scientific FiberLite F14-6x250y Centrifuge Rotor was removed from a university where it was surplus to requirements.
14,000rpm 30,100g.
Bucket width approx 65mm.
Bucket depth approx 118mm.
It is in good cosmetic condition.
Please note this unit has not been safety inspected so it must be safety inspected by a competent engineer prior to use.

£ 966.28 (ex. VAT) 1 in stock
Thermo Scientific FiberLite F14-6x250y Fixed Angle Centrifuge Rotor Lab
ITEM-13903
This Thermo Scientific FiberLite F14-6x250y Fixed Angle Centrifuge Rotor was removed from a university where it was surplus to requirements.
14,000rpm 30,100g.
Bucket width approx 65mm.
Bucket depth approx 118mm.
The unit is in good condition cosmeticall, but it does have some lacquer chipping to the top rim and the lid is also slightly chipped on one edge.
Please note this unit has not been safety inspected so it must be safety inspected by a competent engineer prior to use.

£ 452.68 (ex. VAT) 1 in stock
Thermo Scientific FiberLite F21-8x50y Centrifuge Rotor Lab
ITEM-13759
This Thermo Scientific FiberLite F21-8x50y Centrifuge Rotor was removed from a university where it was surplus to requirements.
The unit is in very good condition with very limited scratches on it. We have however not tested it so it will need a full safety inspection before it is used.
the buckets are approximately 27mm in diameter.
The rotor itself is 23cm in diameter and 17cm in height.

£ 792.20 (ex. VAT) 1 in stock
Thermo Scientific Finnigan Surveyor HPLC Pump Chromatography Lab
ITEM-14315
Thermo Scientific Finnigan Surveyor HPLC Pump Plus Manual.
This unit was removed from a lab during a clear out.
Surveyor LC Pump
Pump operates, but faulty Pump Comms Board (pump does not connect to other modules).
With spare check valve (outlet P/N 00950-30021, and inlet P/N 00950-30026), piston assembly (2, P/N 00950-30020),
Spares or repair.
We have powered on the unit.
But not tested it any further.
Unit seems to be in fairly good cosmetic condition, but has scuffs throughout.
We have disconnected the tubing.

£ POA 1 in stock
Thermo Scientific Flex 900 Recirculating Chiller Lab
ITEM-20213
This Thermo Scientific Flex 900 Recirculating Chiller was removed from a university lab where it was surplus to requirements.
The unit powers up and runs. We were unable to test it with an external thermometer so we had to go off the internal thermometer.
The temperature was set to 20.0ºC, and the internal thermometer measured 20.9ºC.
The temperature was set to 5.0ºC and the internal thermometer measured 5.0ºC.
The temperature was set to 40ºC and the internal thermometer measured 38.5ºC.
The unit has 916 running hours.
The unit is in good cosmetic condition but the liquid filter is missing.

£ POA 1 in stock
Thermo Scientific Fluoroskan Ascent Type 374 Filter Based Plate Reader Lab
ITEM-19395
This Thermo Scientific Fluoroskan Ascent Type 374 Filter Based Plate Reader was removed from a university lab where it was surplus to requirements.
the unit powers on and the plate in/out works but it has not been tested further. We think it requires a PC to operate it further.
It is in good cosmetic condition but has some marks from use.
Comes with a computer cable and User manual. There are slots for software discs in the manual but they are missing.

£ 848.79 (ex. VAT) 2 in stock
Thermo Scientific Focus GC Gas Chromatograph Lab Equipment
ITEM-09224
This unit was removed from a lab as surplus to requirements.
The lab manager assured us it was working when last used, but we have only tested it to power on ourselves.

£ POA 1 in stock
Thermo Scientific Forma Reach-In CO2 Laboratory Incubator Model - 3951 Lab
ITEM-19875
This Thermo Scientific Forma Reach-In CO2 Laboratory Incubator Model - 3951 was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with a digital thermometer (not included). it was first tested at 37˚C which the display reached after about half an hour. (our thermometer only measured it to be 34˚C).
It was then set to 60˚C which the display reached after about 2 hours, though our thermometer only measured 53˚C.
The thermometer read 37˚C when the unit was at 43˚C on the display.
It was not tested with CO2.
It is in reasonably good cosmetic condition with some marks and stains from use.
Internal dimensions - D66.5 x W78.5 x H152cm

£ 300.00 (ex. VAT) 1 in stock
Thermo Scientific GFM Pro Gas Flowmeter Lab
ITEM-18838
This Thermo Scientific GFM Pro Gas Flowmeter was removed from a university lab where it was surplus to requirements.
The unit powers up and was party tested with a beaker of water. It changes from "under range" to multiple levels. It was not tested further. There are no batteries included.
It is in very good cosmetic condition with limited marks from use.
Calibrated: 23/08/2016.
Firmware: Version 5.3.

£ 1,762.50 (ex. VAT) 1 in stock
Thermo Scientific H-6000/H-BB6/HLR-6 Swinging-Bucket Centrifuge Rotor & 6x1000mL
ITEM-13763
This Thermo Scientific H-6000A/HBB-6/HLR-6 PN44040 Swinging-Bucket Centrifuge Rotor was removed from a university where it was surplus to requirements.
Unit comes with 6 X 1000ML Buckets. P/N 44040 5000rpm Max.
The unit is overall in good condition other than a few scratches. It has however not been tested by us so would need a safety inspection before use.
The buckets are 100mm in diameter and the whole unit is 550mm in diameter.

£ 753.65 (ex. VAT) 1 in stock
Thermo Scientific H-6000/H-BB6/HLR-6 Swinging-Bucket Centrifuge Rotor + 6x1000mL
ITEM-13888
This Thermo Scientific H6000/HBB-6/HLR-6 Rotor was removed from a university where it was surplus to requirements.
The Specs are as follows; 6 X 1000ML Buckets. P/N 44040 5000rpm Max. Missing locking stud P/N 11238.
It is in good condition but has been previously used.
The rotor is untested and must be inspected for safety before use.

£ POA 1 in stock
Thermo Scientific HERAcell 150i C02 Laboratory Incubator Lab
ITEM-19374
This Thermo Scientific HERAcell 150i C02 Incubator was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with our digital thermometer (not included). It originally did error because there was no water connected but we did set it to 37C which it reached after about 45 minutes. It was then set to 55C which it reached after a further hour and 25 minutes.
It is in reasonably good cosmetic condition but has some dark scuffs and marks.
Unit dimensions - L80 x W67 x H86cm
Internal - L51 x W47 x H60cm
3 Shelves - 47 x 43cm

£ POA 1 in stock
Thermo Scientific HERAcell Vios 160i C02 Laboratory Incubator Lab
ITEM-20002
This Thermo Scientific HERAcell Vios 160i C02 Laboratory Incubator was removed from a university lab where it was surplus to requirements.
The unit powers on and has been tested with a digital thermometer. It has not been tested with CO2 connected. We were informed it works fine but has a small leak.
We set the temperature to 37˚C which is reached after about an hour, and then the max of 55˚C. It reached 54.8˚C.
It is in reasonably good cosmetic condition but the door handle has snapped off. The door opens and closes fine.
Internal dimensions - D54 W47 H61cm
2 shelves - 47 x 43cm

£ 196.43 (ex. VAT) 1 in stock
Thermo Scientific Heto LyoLab 3000 PowerDry Freeze Dryer Spares Repairs
ITEM-08561
This unit was collected from a lab during a clearout.
Whilst the unit does power on, the display does not light up, so is sold as spares / repairs only.

£ 105.00 (ex. VAT) 1 in stock
Thermo Scientific Hypercarb 250 x 2.1mm 5u HPLC Column 35005-052130 Lab
ITEM-15565
This Thermo Scientific Hypercarb 250 x 2.1mm 5u HPLC Chromatography Column was removed from a laboratory where it was surplus to requirements.
PN: 35005-052130.
The item is in good, used cosmetic condition but we do not know how long it was used.
Column Type | Reversed Phase |
Carbon Load | 100% |
Type | Analytical Column |
Diameter (Metric) | 2.1 mm |
Length (Metric) | 50 mm |
Particle Size | 5 μm |
Pore Size | 250 Å |
Temperature | 105°C |
Product Line | Hypercarb |
Packing Material | Spherical, Porous Graphitic Carbon |
Phase | Reversed Phase |
Column Format | Analytical Column |
For Use With | LC/MS |
Max. Pressure | 5800 psi (400 bar) |
pH | 0 to 14 |
Surface Area | 120 m²/g |
Stationary Phase | Porous Graphitic Carbon |

£ POA 1 in stock
Thermo Scientific MaxQ 3000 Benchtop Orbital Shaker Lab
ITEM-19338
This Thermo Scientific MaxQ 3000 Benchtop Orbital Shaker was removed from a university lab where it was surplus to requirements.
The unit is in good cosmetic condition but it has some minor marks from use. It comes with a number of flask holders and spare screws.
It has been tested at both the minimum speed of 15rpm and the max of 500rpm. It works well. The timer is also working.
The shaker plate measures 91.4cm x 60.6cm.

£ POA 1 in stock
Thermo Scientific MaxQ 6000 Incubator Shaker Model - 4360 Lab Spares/Repairs
ITEM-19907
This Thermo Scientific MaxQ 6000 Incubator Shaker Model - 4360 was removed from a university lab where it was surplus to requirements.
The unit powered up and the shaker was tested to the max of 500rpm. It ran well. The temperature was tested with a digital thermometer (not included). We set the temperature to 37˚C but it tripped the electrics in our testing room when it hit 33˚C. We powered it back up but the same happened again. We could smell electrical smoke so did not test it further.
It is in reasonably good cosmetic condition with some marks from use. The door also does not close properly.
Internal dimensions - D52 x W55 x H67cm
1 Shelf - 52 x 54cm
Shaker Plate - 45 x 45cm
It is sold for spares or repairs due to the electrical fault.

£ 495.30 (ex. VAT) 1 in stock
Thermo Scientific Microm HM 650 V Vibration Microtome Lab Tissue Spares Repairs
ITEM-11069
This microtome was removed from a lab as surplus to requirements.
Unfortunately the unit does not power on so is sold as spares / repairs.

£ 92.38 (ex. VAT) 1 in stock
Thermo Scientific Nalgene Repairable Hand Vacuum Pump 6131-0010 Lab
ITEM-17084
This Thermo Scientific Nalgene Repairable Hand Vacuum Pump 6131-0010 was removed from a university lab where it was surplus to requirements.
The unit is brand new and boxed, but the box has been opened.

£ 1,350.00 (ex. VAT) 1 in stock
Thermo Scientific Neslab ThermoFlex2500 Recirculating Chiller Lab
ITEM-17711
This Thermo Scientific Neslab ThermoFlex2500 Recirculating Chiller was removed from a university lab where it is surplus to requirements.
The lab assured us the unit was working, except that it occasionally had an unexplained high temperature alarm.
At our site, the unit powers on but has not been tested further. It is in good cosmetic condition with only light usage marks on it.
Specs:
Description | ThermoFlex 2500 Recirculating Chiller | |
Pump Capacity | Up to 3.3 gpm @ 60 psig (12.5 L/min. @ 4.1 bar) (50Hz) | Up to 4.0 gpm @ 60 psig (15. |
Temperature Stability | &plusnm;0.1°C | |
Certifications/Compliance | CE, CSA Semi S2 | |
Communications | Analog & Digital (available) | |
Condenser Type | Air Cooled or Water Cooled | |
Cooling Capacity | Up to 2,500 watts (60Hz) 2,200 watts (50Hz) | |
Temperature Range | 5°C to 90°C |
Items 2901 to 2920 of 3286