All Products

This unit was removed from a lab as surplus to requirements.

It appears to be in good condition and on tested reached 53C.

This unit was removed from a lab as surplus to requirements.

It appears to be in full working order and good condition.

This unit was removed from a lab as surplus to requirements.

We were assured the unit was in working order prior to removal.

On testing the unit, it appears to heat without any problems. We did not test the CO2 function ourselves.

LEEC P2K Laboratory CO2 Incubator

Recently collected from a working laboratory as a surplus to requirements.

This units is in very good condition and working order.

This unit was removed from a lab during a clearout.

The unit powers up but does not heat up.

We have not tested it further.

LEEC SSS - 100L Lab Glassware Drying Cabinet Warming Oven

This unit was recently removed from a working laboratory in a leading UK university.

Very clean unit and in excellent working order.

LEEC SSS - Drying Oven Lab Glassware Drying Cabinet 100L Capacity

This unit was recently removed from a working laboratory in a leading UK university.

Very clean unit and in excellent working order, like new.

This objective was removed from a lab as surplus to requirements.

We have not tested the objective - however if upon receipt your are not satisfied with its operating condition we will happily accept a return in exchange for a refund within 45 days.

Leica AFS Freeze Substitution Unit w/ Control Unit

1 x Leica 655601

1 x Leica EM UV 702727

1 x Leica EM AFS 702701

1 x Leica EM AFS Manual (in German)

6 x Leica Cases containing various accessories

1 x Steel Container containing various accessories

This equipment originated in a working Laboratory in a top UK University. We were informed by our contact at the Uni that the equipment was serviced in 2015 but the access plate broke (see photo 6) at some point since then. Prior to this the equipment was working.

Now we are unsure whether the unit is functional / safe for use with this damage so it may need replacing prior to use.

This knife holder set was removed from a lab as surplus to requirements.

This unit was removed from a lab as surplus to requirements.

The lab manager assured us it was fully functional and in good working order.

We conducted some basic testing of the refrigeration and operational parts and the unit does appear to be fully working.

Leica CTR6000LX Electronics Box for AF6000LX System (Live Cell Imaging).  This Equipment originated in a working Lab in a top UK University and came to us as part of a Lab clear out.  Cosmetically it is in great condition and powers up but we do not have the expertise to test further.

This system is complete and being sold on behalf of a university lab as surplus to requirements. It has now been packed up by our lab removals team and is stored at our site. Viewings are welcome.

This microscope has an inverted stand (Leica DM IRE2).

For excitation, it is equipped with an Argon ion laser and two HeNe lasers giving lines at 458, 476, 488, 514, 543 and 633 nm.

Emitted fluorescence can be collected between 350 and 850 nm using three standard photomultiplier tubes with emission controlled by an AOTF, the latter also allowing spectral analysis across the whole range in 5 nm increments.

The forms of transmitted light detection available include brightfield, phase and DIC (dependent upon the objective).

Types of experiment include Z-stack, time series, FRAP and FRET.

Objectives are:

Air objectives - 10x (0.3 NA), 40x (0.75 NA), 63x (0.7 NA, corr.);

Oil objectives – 25x (0.75 NA), 40x (1.25 NA) and 63x (1.4 NA).

These 6 objectives are described further with the text below:

pl fluotar 25x/0.75 ph2

hcx pl apo 63x/1.40-0.60 oil

hc pl fluotar 10x/0.30 ph1

pl fluotar l63x/0.70 corr ph2

hcx pl apo 40x/0.75 u-v-1

hcx pl apo 40x/1.25 oil ph3 cs.

The microscope stand is mounted on an active, vibration-isolation table, and the system is controlled with Leica LCS software running on a WinXP computer.

For physical dimensions: (Please note these are rough dimensions only - if you need precise measurements for a room please enquire and we will check).

The microscope table is about 80x80x80cm. The monitor table is about 80x100x80cm. The source unit is about 80x120x80.

1. From a top UK University
2. This has been pulled direct from a working lab and was working prior to removal. We have only tested it with power on at our end but there seems to be no problems.
3. There is a Jun-Air Model 600-5M Included which works
4. There is also the Leica software for windows 95/98

Also a lot of Leica accessories included.

1. Please see photos for more.

All of this is on a cart with wheels for easy transport

Leica Gallen III - Binocular Microscope with 4 objectives

Originated in a working laboratory in a top UK university and came to as as a part of Lab clear out.

This microscope comes with the following objectives:

• 1 x Leica Plan 10/0.25 (160/0.17)
• 1 x Leica Plan 4/0.1 (160/0.17)
• 1 x Leica Plan 40/065 (160/0.17)
• 1 x Leica Plan 100/1.25 OIL (160/0.17)

Eyepieces Lenses:

• 2 x WF 10X/18

This unit was removed from a lab as surplus to requirements.

We were assured it is in full working order.

This unit was removed from a university store-room during a clearout. We have not tested the unit.

This unit was removed from a store room as surplus to requirements. The unit powers on but has not been tested further.

This unit was removed from a lab during a clearout.

The unit powers on but there it looks like it needs a new bulb. There are no objectives.

This unit was removed from a lab as surplus to requirements.

We were assured the unit was in full working order prior to removal.

The unit comes with four objectives:

*160/- PL Fluotar 10/0.30,

160/- PL 1.6/0.05,

*160/0.17 PL Fluotar 100/1.32 OIL,

160/0.17 PL Fluotar 40/0.70,