All Products
Items 2001 to 2020 of 3068
£ 205.00 (ex. VAT) 1 in stock
LUDL Electronic Products 7 Slot Card Cage Interface Controller Cat no. 73000101
ITEM-25266
This LUDL Electronic Products 7 Slot Card Cage Interface Controller Cat no. 73000101 was removed from a university lab where it was surplus to requirements.
The item powers on but has not been tested further.
The item is in a reasonable, used cosmetic condition.
£ 205.00 (ex. VAT) 1 in stock
Bosch Ultramed Model 11S 601 Shortwave Therapy Unit Lab
ITEM-28332
This Bosch Ultramed Model 11S 601 Shortwave Therapy Unit was removed from a university lab where it was surplus to requirements.
The unit powers on and is in good cosmetic condition There are some light tape marks and scuff marks from general use. All knobs and dials appear responsive to the unit.
The lab confirmed it was working prior to removal.
With it are;
1x Circuplode
Art No. 8 698 140 752
1x Circuplode-Adaptor
Art No. 8 694 446 972
Manuals:
1x Instruction manual
1x Treatment and therapy manual.
3x Chart guides
£ 205.00 (ex. VAT) 1 in stock
Mechtric Stevens CR Texture Analyser Lab
ITEM-18889
This Mechtric Stevens CR Texture Analyser was removed from a university lab where it was surplus to requirements.
The unit powers up and runs. The Test head moves up and down when pressing start/stop. It has not been tested further.
It is in reasonably good cosmetic condition but has some marks from use.
£ 205.00 (ex. VAT) 1 in stock
Verder Industrial Gear Pump Type 2032 Lab
ITEM-28078
This Verder Industrial Gear Pump Type 2032 was removed from a university lab where it was surplus to requirements.
The unit powers on and is in reasonably good cosmetic condition. Air could be felt blowing out the back of the unit.
All buttons and switches appear to be responsive.
£ 205.00 (ex. VAT) 1 in stock
Major Science Gel Dryer Model - MG-2131 Lab
ITEM-25250
This Major Science Gel Dryer Model - MG-2131 was removed from a university lab where it was surplus to requirements.
The item powers on and was tested with a digital thermometer (not included).
The temperature was first set to 37˚c, which it reached quickly (thermometer read 37.9˚c)
The temperature was then set to its maximum of 100˚c but it would only go up to around 80˚c then drop back down a few degrees and fluctuate, the maximum thermometer reading was 83˚c.
The item is in a reasonable, used cosmetic condition.
£ 205.00 (ex. VAT) 1 in stock
Haca Leitern 7656/05 5 Step Steel Mobile Safety Warehouse Steps 1 Metre
ITEM-35812
Haca Leitern 7656/05 5 Step Steel Mobile Safety Warehouse Steps 1 Metre
This was removed from a university lab where it was surplus to requirements.
It is in good cosmetic condition with marks from use.
Max load weight 150Kg
£ 205.00 (ex. VAT) 1 in stock
Gynkotek High Precision HPLC Pump Model 300 Type: M 300 CS Lab
ITEM-18941
This Gynkotek High Precision HPLC Pump Model 300 was removed from a university lab where it was surplus to requirements.
The unit powers up and the displays and dials seem responsive but it has not been tested further.
The unit is in reasonably good cosmetic condition with some minor paint chips and blemishes.
£ POA 1 in stock
Powertecnique Uninterruptable Three-Phase Power Supply & Battery Box Lab
ITEM-20369
This item is new in stock. Please enquire for further details.
NEW ITEM
NEW ITEM
£ 200.00 (ex. VAT) 5 in stock
SCILOGEX MS-S Circular Analog Magnetic Stirrer Lab
ITEM-25535
This SCILOGEX MS-S Circular Analog Magnetic Stirrer is being sold on behalf of a client.
The unit is brand new and unused.
We have several of these in stock in identical condition.
£ 200.00 (ex. VAT) 1 in stock
Protex Ventilated Workstation Model/Type - VB FH Lab
ITEM-31712
Protex Ventilated Workstation Model/Type - VB FH
This was removed from a university lab where it was surplus to requirements.
The unit is in reasonably good cosmetic condition with minor marks from use.
It has not been tested as it needs a power cable wired up.
Workstation surface - 140 x 70cm
£ 200.00 (ex. VAT) 1 in stock
Edwards Modulyo K4 Freeze Dryer Lab
ITEM-34744
Edwards Modulyo K4 Freeze Dryer
This was removed from a university lab where it was surplus to requirements.
The unit powers up and looks to be in working order. We were unable to get a true measure of the cooling system as the top part of the drum was missing.
It is in good cosmetic condition with marks from use.
Internal dimensions are: L 12.5cm x W 12.5cm x H 27cm.
£ 200.00 (ex. VAT) 1 in stock
Ophir Laser Power Monitor with Gentee Joulemeter ED-200 Lab
ITEM-25449
Ophir Laser Power Monitor with Gentee Joulemeter ED-200
This was removed from a university lab where it was surplus to requirements.
It has not been tested but is in reasonable cosmetic condition.
£ 200.00 (ex. VAT) 1 in stock
Sanyo CO2 Laboratory Incubator Model - MCO-17AI Lab
ITEM-27470
This Sanyo CO2 Laboratory Incubator Model - MCO-17AI was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with 5% CO2 and measured with a digital thermometer (not included).
It was set to 37˚C which it reached in 2 hours. It was then set to 50˚C which took a further hour to reach.
The digital thermometer was consistent with the readings on the display.
The plastic door handle has snapped but that doesn't seem to affect the operation of the unit at all.
Internal dims - D49.5 W49 H65cm
2 Shelves - 45 x 45cm
£ 200.00 (ex. VAT) 1 in stock
Cellomics ArrayScan 2 HCS High Content Screening System
ITEM-05713
This unit was removed from a working laboratory as surplus to requirements. We were informed the system was working, but have not tested it beyond power-up on our end.
The software and manual is included
£ 200.00 (ex. VAT) 1 in stock
Sartorius ARIUM 6112 UF Water Purification System Lab
ITEM-23944
This Sartorius ARIUM 6112 UF Water Purification System was removed from a university lab where it was surplus to requirements.
We powered the unit on with no problems. The screen works well. The self-check system works with no issues but no further testing was carried out.
The unit is in good overall condition but does have some age and usage-related marks.
RECERTIFIED ITEM
RECERTIFIED ITEM
£ 200.00 (ex. VAT) 1 in stock
RS Biotech Galaxy S+ 170-200 Plus CO2 Laboratory Incubator Lab
ITEM-35093
This RS Biotech Galaxy S+ CO2 Laboratory Incubator was removed from a university lab where ti was surplus to requirements.
The unit powers up and has been professionally serviced. It is in full working order. A full report is available on request. It will require calibration upon installation.
It is in good cosmetic condition with minor marks from use.
3 Shelves - 52 x 42.5cm
£ 200.00 (ex. VAT) 1 in stock
Carl Zeiss Axio Microscope 2Fl Filter Slider Zeiss filter no. 25 - 45 17 66
ITEM-27670
This Carl Zeiss Axio Microscope 2Fl Filter Slider was removed from a university lab where it was surplus to requirements.
Carl Zeiss Axio Microscope 2Fl Filter Slider
Zeiss filter no. 25
Part no. 45 17 66
The item is in good cosmetic condition. There are some scratches/signs of prior use. The filters are clear and without marks.
It has not been tested with a microscope.
£ 200.00 (ex. VAT) 1 in stock
Bohlin Instruments Re-Circulator Model - KTB 50 Lab
ITEM-20675
Bohlin Instruments Water Bath Re-Circulator Model - KTB 50
This was removed from a university lab where it was surplus to requirements.
The unit powers up but we have not carried out any further tests on this unit as there are no clear temperature controls for the fluid. We suspect this must be controlled by a Bohlin Rheometer (which we do not have).
It is in reasonably good cosmetic condition with some marks from use.
£ 200.00 (ex. VAT) 1 in stock
3 x Microlink Modular Rack Units - 3000 - For Measurement & Control Lab
ITEM-24354
3 x Microlink Modular Rack Units
These were removed from a university lab where they were surplus to requirements.
There are 2 x 3000 units and one is just marked "microlink". They all contain several modules each.
All the units power up but have not been tested any further. They are in a reasonable, used cosmetic condition.
£ 200.00 (ex. VAT) 1 in stock
NAPCO Water-Jacketed CO2 Laboratory Incubator Model no. 7101 Lab
ITEM-19305
This NAPCO Water-Jacketed CO2 Laboratory Incubator Model no. 7101 was removed from a university lab where it was surplus to requirements.
The unit powers up and has been tested with a digital thermometer (not included0. It was first set to 37˚C which it reached after about half an hour. It was then set to the max of 50˚C which it reached after about 2 hours. Our thermometer measures the temperature at 59˚C. It was not tested with water or CO2.
It is in reasonable cosmetic condition but has plenty of marks and stains from use.
Internal dimensions -D42 x W46 x H63cm
3 Shelves - 42.5 x 42.5cm
Items 2001 to 2020 of 3068