All Products

RECERTIFIED ITEM

£ 3,345.00 (ex. VAT) 1 in stock

Thermo Scientific Heracell 150i CO2 Laboratory Incubator Lab

ITEM-31980

This Thermo Scientific Heracell 150i CO2 Laboratory Incubator was removed from a university lab where it was surplus to requirements.

The unit powers up and has been fully tested. It is in full working order. It will need calibrating upon arrival at its new location.

It is in good cosmetic condition and has had a brand-new door hinge and screen fitted.

Internal dimensions - L49 W45 H60cm

3 Shelves - 46.5 x 42.5cm

RECERTIFIED ITEM

£ 3,335.00 (ex. VAT) 1 in stock

New Brunswick Innova 4400 Floor Standing Shaking Incubator Lab

ITEM-25606

New Brunswick Innova 4400 & Innova Shaking Incubator.

This was removed from a university lab where it was surplus to requirements.

The unit has been assessed by a service engineer and has had the following replacement parts fitted.

Motor.

Temperature sensor bracket.

Door mechanism.

Gas struts.

Base.

Various panels.

It has been tested at various speeds and is shaking well.

It has been temperature tested at:

37ºC - It reached this temp fine. We calibrated it with our SmartVue Thermometer (not included).

80ºC - It reached 73ºC and it was at this temperature for quite a while.

The unit is in good cosmetic condition but has marks from use.

The manual is supplied.

RECERTIFIED ITEM

£ 3,315.00 (ex. VAT) 1 in stock

Thermo Fisher Scientific Sorvall ST 40 Benchtop Laboratory Centrifuge Lab

ITEM-19024

This Thermo Fisher Scientific Sorvall ST 40 Benchtop Laboratory Centrifuge was removed from a university lab where it was surplus to requirements.

It is in very good cosmetic condition but has some marks from use.

It has been recertified by a service engineer and has been fully tested. It is in full working order. It is fitted with a TX-750 Rotor.

The Diagnostics menu shows the centrifuge has only been used 960 times.

RECERTIFIED ITEM

£ 3,310.00 (ex. VAT) 1 in stock

Leica DMRBE Fluorescence Trinocular Microscope & 4 x Objectives PL FLUOTAR Lab

ITEM-20148

This Leica DMRBE Fluorescence Trinocular Microscope was removed from a university lab where it was surplus to requirements. The lab assured us this unit was in full working order when last used.

The unit has been inspected and certified by a microscope engineer. The report is available on request. It is in good working order. No major defects were identified.

It is in good cosmetic condition with some light marks from use.

TYP: TCS NT

Included with it are;

2x LEICA eye pieces

L PLAN 10X /25 M

and 4 x Objectives.

1x LEICA PL FLUOTAR 5X/ 0.12

1x LEICA PL FLUOTAR 10X/ 0.30 PH 1

1x LEICA PL FLUOTAR 20X/ 0.50 PH 2

1x LEICA PL FLUOTAR 40X /1.00 0IL PH 3

£ 3,295.00 (ex. VAT) 1 in stock

Bright Microtome 5040 Laboratory Cryostat Lab

ITEM-23971

This Bright Microtome 5040 Laboratory Cryostat was removed from a university lab where it was surplus to requirements.

The unit powers up and the light works. It has been tested with a digital thermometer (not included).

It was set to -35˚C. We ran for it for 6 hours and Quick Freezer Temperature got to -35˚c, Specimen Temperature got to -14˚c and the chamber Temperature got to -15˚c.

£ 3,280.00 (ex. VAT) 1 in stock

Honeybee 8+1 Nano Dispensing System Genomic Solutions Cartesian Lab

ITEM-21159

This system was removed from a university lab as surplus to requirements. The lab reported: "Hasn’t been used for a few years. I am told it was working fine last time. "

Genomic Solutions Cartesian Dispensing System ,Honeybee SD 8+1 Active. Model 6PCSDBXL-00.

The system in the perspex enclosure was in good working order prior to it being disconnected. There is also included a spare unit which the university was using to provide spare parts.

There are eight tube rails each holding 24 tubes.

There are two Dell GX520 PC's that both have Microsoft XP pro installed and the software for the honeybee installed. There are no personal data on either of the units and all passwords and usernames have been changed on both. A HP 1702 monitor, usb keyboard and mouse are also included.

It also comes with instruction books and a CD-Rom of software with Cartesian AXSYS V81.6.2.

£ 3,265.00 (ex. VAT) 1 in stock

Thermo Scientific Surveyor HPLC System - PDA Detector, MS Pump & Autosampler Lab

ITEM-24458

This Thermo Scientific Surveyor HPLC System was removed from a university lab where it was surplus to requirements.

Included are;

1 x Autosampler

Part no. SRVYR-AS

1 x MS Pump

Part no. SRVYR-MPUMP

1 x PDA Plus Detector

Part no. SRVYR-PDA5P

All the components power up but have not been tested further. They are in reasonably good cosmetic condition but have marks from use.

£ 3,255.00 (ex. VAT) 1 in stock

Kruss Digital Tensiometer Model: K 10 ST Lab

ITEM-24833

This Kruss Digital Tensiometer Model: K 10 ST was removed from a university lab where it was surplus to requirements.

The item is in reasonable cosmetic condition. The paint is worn/chipped in some places. There are stains and other marks on the edges.

The item powered on fine. It responded to inputs from the dials but it couldn't be tested further.

Also included are the following:

1x Manual

1x Glass dish

1x Pyrex 0.5ml

1x Recorder wire

The extra pieces are inside the tensiometer.

£ 3,240.00 (ex. VAT) 1 in stock

Analytik Jena AlphaSC Samplerblock Thermal Cycler Lab

ITEM-29877

This Analytik Jena AlphaSC Samplerblock Thermal Cycler was removed from a university lab where it was surplus to requirements.

The unit powers up and runs.

It is in good cosmetic condition with marks from use.

48/R9-96/R4.5

340:720.14

£ 3,240.00 (ex. VAT) 1 in stock

Metrohm 842 Titrando with 801 Stirrer & 800 Dosino - Titration System Lab

ITEM-35113

Metrohm 842 Titrando with 801 Stirrer & 800 Dosino - Titration System

The system was supplied to us without a controller, for this reason it is sold as untested.

It is in good cosmetic condition with minor marks from use.

Included are;

Metrohm 842 Titrando

No. 1842001006127

Metrohm 801 Stirrer

No. 1801001030336

Metrohm 800 Dosino

No. 1800001055453

Metrohm Probe

No. 10322381

£ 3,230.00 (ex. VAT) 1 in stock

Soxtec Avanti 2050 Auto Fat Extraction System with Drive Unit Lab

ITEM-24537

This Soxtec Avanti 2050 Auto Fat Extraction System was removed from a university lab where it was surplus to requirements.

Included are;

1 x Foss Tecator 2050 Soxtec Avanti Auto Extraction Unit

Part no. 10007330

1 x Foss Tecator 2050 Drive Unit

Part no. 10007338

The item powers on with the drive unit supplying power and controlling the extraction unit. It was not tested further. It seems to be missing a control unit.

The item is in reasonably good cosmetic condition with some marks from use.

£ 3,215.00 (ex. VAT) 1 in stock

Thermo Scientific VersaCool Refrigerated Circulating Water Bath Lab

ITEM-24423

This Thermo Scientific VersaCool Refrigerated Circulating Water Bath was removed from a university lab where it was surplus to requirements.

The unit powers up and is in very good cosmetic condition. It was tested with a digital thermometer (not included).

Heating:-

Tested with water, the temperature was set to 37˚c, the temperature quickly went up to 38˚c while the thermometer read 37˚c. It was then tested up to the maximum temperature (for water) of 90˚c which it reached after around 10 minutes, thermometer also read 90˚c. It can go higher but we didn't want it to boil. It is rated for 150˚C.

Cooling:-

Tested with Antifreeze, the temperature was set to -20˚c, it dropped quite quickly to -8˚c but seemed to stop cooling from there, only dropping a further 0.3˚c over the next few hours. The thermometer read -9.6˚c. This is likely due to the concentration of antifreeze used.

£ 3,190.00 (ex. VAT) 1 in stock

Bio-Rad Gene Pulser Xcell Microbial System with CE Module & Shock Chamber

ITEM-35469

Bio-Rad Gene Pulser Xcell Microbial System with CE Module & Shock Chamber

This was removed from a university lab where it was surplus to requirements.

The system powers up and is in good cosmetic condition with marks from use.

Included are;

Bio-Rad GenePulser Xcell

Model number- GenePulser Xcell

Serial number- 617BR02348

Bio-Rad CE Module

Model number- CE Module

Serial number- 618BR 02069

Bio-Rad ShockPod

£ 3,185.00 (ex. VAT) 1 in stock

CEM MarsX Microwave Digestion Oven Model no. 907610 Lab

ITEM-26221

This CEM Mars X Microwave Digestion Oven Model no. 907610 was removed from a university lab where it was surplus to requirements.

The university said the last person to use it prior to removal said it was in full working order.

The item powers on and doesn't appear to have any issues other than scheduled maintenance. The photos make it appear otherwise but the screen is fine.

It is in good cosmetic condition with only minor marks from use.

It comes with 12 x XP-1500 Plus Vessel Accessory Sets, spare turntables & safety membrane holders - 38mm diameter. Another spare turntable holds 40 x 22mm tubes.

Other accessories:-

Marsx Extraction Application Disk

Pen Vac

Tools

Tubing

Other various small parts in bags

Manuals for Mars5 &XP-1500 Vessel Accessory sets

External dimensions - D62 W52 H58cm

Internal - D34 W42 H33cm

£ 3,185.00 (ex. VAT) 1 in stock

Fluidigm C1 Single Cell Auto Prep System mRNA Sequencing Lab

ITEM-23408

This Fluidigm C1 Single Cell Auto Prep System was removed from a university la where it was surplus to requirements.

The unit powers up and the internal compressor is working. We were unable to test it fully without the standards set required.

It is in excellent cosmetic condition but has some minor marks from general use.

£ 3,185.00 (ex. VAT) 1 in stock

3D Systems Corporation ProJet 3500 - 3510/3500 HD Max 3D Printer

ITEM-31718

This 3D Systems Corporation ProJet 3500 HD Max 3D Printer was removed from a university lab where it was surplus to requirements.

The unit powers up and is in good cosmetic condition with minor marks from use. It was not tested at our facility, but we are told it was working 3 years ago when last used.

£ 3,175.00 (ex. VAT) 1 in stock

Carbolite Laboratory Furnace Model - VCF 12/23 Lab

ITEM-27498

This Carbolite Laboratory Furnace Model - VCF 12/23 was removed from a university lab where it was surplus to requirements.

The unit was fitted with a 32 amp plug (not included). It is in full working order. It has been tested and fitted with a replacement temperature controller by an engineer.

It is in reasonable cosmetic condition but has some dents.

£ 3,170.00 (ex. VAT) 1 in stock

Leica MZ95 High-Performance Stereomicroscope Stereo Zoom Lab

ITEM-23434

This Leica MZ95 High-Performance Stereomicroscope was removed from a university lab where it was surplus to requirements.

The unit is in good used cosmetic condition but it does have various marks and signs of general use.

It has been tested and appears to work as it should. Note there is no cable or PSU to power the attached Leica L2 gooseneck lamps. These have not been tested.

The microscope is fitted with the following parts:

1 x Leica 10445619 AS Binocular head.

Fitted with 2 x Leica 10445111 10x/21B eyepeices.

1 x Leica 10 446272/5092251 Optics Carrier.

Fitted with the following objectives:

0.63x

0.8x

1.0x

1.25x

1.6x

2.0x

2.5x

3.2x

4.0x

5.0x

6.0x

It is also fitted with a:

Leica 10 445 819 Planachromatic 1.0x lens.

NOTE: The circuit board shown is for demo purposes only!

£ 3,160.00 (ex. VAT) 1 in stock

New Brunswick Scientific Innova 4330 Refrigerated Shaking Incubator

ITEM-29942

This New Brunswick Scientific Innova 4330 Refrigerated Shaking Incubator was removed from a university lab where it was surplus to requirements.

The unit powers up and the incubator and shaker have both been tested (digital thermometer not included). It is in full working order.

The unit is in good cosmetic condition but the lid seal is starting to detach and likely needs replacing.

Internal Dimensions - 87 x 56 x 34 cm (up to the top where the lid would seal)

NEW ITEM

£ 3,145.00 (ex. VAT) 1 in stock

ESI Probe Assembly PN 700004254 Waters Xevo with Spares & Installation Kit Lab

ITEM-31719

ESI Probe Assembly PN - 700004254

This was removed from a university lab where it was surplus to requirements.

It comes with;

ESI Probe Installation Kit (289003857) Sealed

ESI Probe Spares Kit (20500530) Sealed

Certificate of Conformity

All Products

Filters